When hooking up the hoses to the
PJR The hose diameter is the same
but the fittings are different sizes so
they can only go on one way.
And there is a male and female on
either side so you can add a second
set either at the pump or at the gun.
When you’re connecting the hose
to the gun, it is the male size of the
hose that goes into the smaller
fitting typically on the left side.
When you go to spray, pull the black
handle back away from the blue
point and then it is in the ON position
as showed here.
When you are purging materials
through the hoses you must have
the gun in the open position to
allow the air to escape.
There is a drill bit placed next to the
tip of the gun used for cleaning.
Hose Connection Overview
The gun is in the closed position.
Make sure to tighten each
connection lightly.
The bit supplied can be used to
clean out both of the holes near the
tip if needed in case of a clog.
Be sure to carefully tighten each
hose connection.
800.620.7928
PAGE 19
WWW.PATRIOTJR.COM
Add on the whip hoses that are the
same blue and red colors.
FLEECEBACK & INSULATION MOBILE ADHESIVE DISPENSING CART
Summary of Contents for P-55
Page 1: ......