AMOT 10GEF, Operation And Maintenance Manual, Page: 60 / 80

60
System Integration
Rev 12 – NOV 2019 OMMG00012
Temperature Sensor Installation
•
Position as close as possible to the point of control.
•
Ensure positioned at least 6 pipe diameters in length from any junction.
•
Ensure the end 40 mm of probe is a close as possible to the centre of the
flow path.
•
Do not run cables in very hot areas which can cause cable failure and
inaccurate measurement.
• Avoid installation in areas of high vibration.
•
Avoid installation into potential air pockets.
•
Position in an accessible location for future maintenance access.
• Use heat transfer compound in thermal well.
Controller Installation
The installation will be affected by the choice of controller components. Refer
to manual OMM807100043 (PID Controllers) for specific installation details.