4G PoE IIoT Gateway
WDS Hybrid Mode
For the WDS Hybrid mode, the device bridges all the wired
LAN
and
WLAN
clients to another WDS or WDS
hybrid enabled WiFi devices which the device associated with.
WDS Hybrid Mode
Item
Value setting
Description
Lazy Mode
The box is checked by
default.
Check the
Enable
box to activate this function.
With the function been enabled, the device can auto-learn WDS peers without
manually entering other AP’s MAC address. But at least one of the APs has to fill
remote AP MAC addresses.
Green AP
The box is unchecked
by default.
Check the
Enable
box to activate
Green AP
function.
VAP Isolation
The box is checked by
default.
Check the
Enable
box to activate this function.
By default, the box is checked; it means that stations which associated to different
VAPs cannot communicate with each other.
Time Schedule
A Must filled setting
Apply a specific
Time Schedule
to this rule; otherwise leave it as
(0) Always
.
If the dropdown list is empty ensure
Time Schedule
is pre-configured. Refer to
Object
Definition
>
Scheduling > Configuration
tab.
Scan Remote AP’s
MAC List
Available when Lazy
Mode disabled.
Press the
Scan
button to scan the spatial AP information, and then select one from
the AP list, the MAC of selected AP will be auto filled in the following Remote AP
MAC table.
Remote AP MAC
1~4
Available when Lazy
Mode disabled.
Enter the remote AP’s MAC manually, or via auto-scan approach, The device will
bridge the traffic to the remote AP when associated successfully.
By default, VAP 1 is enabled and security key is required to connect to the gateway wirelessly to enhance the
security level and prevent unexpected access of un-authorized devices.
The default wifi key is printed on both the device label and the Security Card. It is created randomly and
96