26
Amico Clinical Solutions Corp.
Installation: Spring Arms
Initial Setup
Installing/Removing the Spring Arm
1. Press and turn the plastic cover cap on each side,
remove them, and set them aside.
2. Use a 4mm Allen key to remove the two M4-6 screw
securing the front plastic cover on each side and
remove both the front plastic covers.
1. Use a Phillips head screw driver to remove the two 6-8
screws on either side on the top of the adaptor weld
and remove the plastic slip ring holder.
Note:
Be careful when dealing with the 9-pole male
connector, if it gets bent, it will not mesh properly.
2. Loosen the two friction screws in the side of the adaptor
weld. Slide the rear weld tube of the Spring Arm into
the adaptor weld through the bottom. Ensure that the
rear weld tube is inserted all the way in, pressure must
be applied upwards to the area directly below the
adaptor weld.
3. On the top side of the adaptor weld, put two spacer
shims onto the extruding rear weld tube.
