16
Amico Clinical Solutions Corp.
Order Components for each Threaded Rod:
1. Attach two hex nuts, one lock washer and one flat washer to one threaded rod in the configuration shown below.
Then drop the threaded rod through the top of the structural plate at the specified hole locations shown on the
previous page.
2. Repeat the above procedure with the remaining rods (12 total for dual mount; 8 total for single mount) that are
required for the installation of the anchor plate to the structural plate.
3. Carefully align and raise the anchor plate up to the mounting rods until the bottom face of the anchor plate is
10" (254 mm) above the bottom of the finished ceiling.
4. Attach the associated hex nut, lock washers and flat washers in the correct configuration as shown below.
Tighten the M16 hex nuts to 145 lbs-ft using a torque wrench.
!
WARNING – Risk of Pendant System Dropping
If the threaded rods are not completely screwed in, it may cause the pendant system to drop suddenly.
5. Install additional terminal strips for low voltage, video or communication lines on the interface plate according to
the order specific configuration sheet in the submittal package.
Order Components for each Threaded Rod:
Installation: Structure Plates and Flanged Ceiling Tube
• 2 x Hex Nuts
• 1 x Lock Washer
• 1 x Flat Washer
• Structural Plate
• 1 x Flat Washer
• 1 x Lock Washer
• 1 x Hex Nut
• 1 x Hex Nut
• 1 x Lock Washer
• 1 x Flat Washer
• Anchor Plate
• 1 x Flat Washer
• 1 x Lock Washer
• 2 x Hex Nuts
REV.
DESCRIPTION
BY
DATE
5
4
3
1
55 East Wilmot St.
Richmond Hill, Ontario
L4B 1A4, CANADA
Tel: (905)764-0800
Fax: (905)764-0862
DESCRIPTION:
PART NO:
SHEET:
OF
DRAWING NO:
1
1
PROJECTION
PRIVATE AND CONFIDENTIAL
THIS PRINT IS PROPERTY OF AMICO CLINICAL AND IS LOANED IN CONFIDENCE SUBJECT TO RETURN UPON
REQUEST AND WITH THE UNDERSTANDING THAT NO COPIES ARE TO BE MADE WITHOUT THE CONSENT OF
AMICO CLINICAL.
ALL RIGHTS TO DESIGN OR INVENTION ARE RESERVED
2019-04-09
DATE:
2019-04-09
DATE:
VC
CHECKED BY:
AC
DRAWN BY:
NTS
SCALE:
2
A
B
C
D
SEE NOTE 2
FINISH:
MATERIAL:
SEE NOTE 1
YYMMDD-XXX
UNLESS SPECIFIED:
ALL DIMENSIONS IN INCHES
SURFACE FINISH 63 uin
BREAK ALL EDGES 0.005 - 0.010
REMOVE SHARP EDGES AND BURRS
ANGLE TOLERANCES 0.25
CONCENTRICITY OF 0.005"
STRAIGHTNESS & FLATNESS
PARALLELISM OF 0.005"
DECIMAL TOLERANCES: X.XX .05
X.XXX .005
X.XXXX .0005
CA DROP TUBE WELDMENT
CA-DT-S1-XXX-ASY
