11
Amico Accessories Inc.
Mount the Handle (Optional)
WARNING:
DO NOT TIGHTEN ONE SCREW ALL THE WAY PRIOR TO INSERTING THE OTHER. START BY INSERTING
BOTH SCREWS HALF WAY, THEN TIGHTEN EACH SCREW INCREMENTALLY, ENSURING THAT THE TWO
HALVES OF THE HANDLE REMAIN PARALLEL WITH ONE ANOTHER. FAILURE TO DO SO MAY CAUSE
DAMAGE TO THE EQUIPMENT.
1. Place handle at desired height (typically 2" (5.08 cm) below the
POST ADAPTER
), place the
ROLL STAND HANDLE
BACK PIECE
and
ROLL STAND HANDLE FRONT PIECE
around the
ROLL STAND POST
. Secure the
ROLL STAND HANDLE
in
place by inserting the
HANDLE KIT SCREWS
through the back piece and tightening into the larger piece, using a
#2 Phillips head screwdriver.
(Figure 1)
Figure 2
HANDLE KIT SCREWS
[H-PHMS-1032-916]
(PART OF RS1-HANDLE)
2X
SMALLER PIECE OF
ROLL STAND HANDLE
[RS1-HANDLE]
STAND POST
[X-RS-POST-125]
LARGER PIECE OF
ROLL STAND HANDLE
[RS1-HANDLE]
INCORRECT
CORRECT
Correct
Incorrect
Section 3: Assembly
HANDLE KIT SCREWS
[H-PHMS-1032-916]
(PART OF RS1-HANDLE)
2X
SMALLER PIECE OF
ROLL STAND HANDLE
[RS1-HANDLE]
STAND POST
[X-RS-POST-125]
LARGER PIECE OF
ROLL STAND HANDLE
[RS1-HANDLE]
INCORRECT
CORRECT
SMALLER PIECE OF ROLL
STAND HANDLE
[RS1-HANDLE]
LARGER PIECE OF ROLL STAND HANDLE
[RS1-HANDLE]
ROLL STAND POST
[X-RS-POST-125]
2x
HANDLE KIT SCREWS [H-PHMS-1032-916]
(PART OF RS1-HANDLE)
Figure 1
Installing Extender Plates for Larger Tablets (RS8-UPGRD-TB13)
Introduction
The purpose of this KIT is to upgrade the existing tablet mount to accommodate larger tablet range from
11" - 13.5" (27.9 cm - 34.3 cm) to 13.5" - 15.5" (34.3 cm - 39.4 cm) (corner to corner) size and thicker tablets or tablet
case from 0.4" - 0.8" (1.02 cm - 2.03 cm) thick.
Installation Tools
Hardware Kit
#T10 & #T20 Torx Allen key
(Included in the KIT)
Spacers
Extender plates
