13
Amico Accessories Inc.
Section 3: Assembly
Figure 6
Figure 7
5. Replace the existing clamp plate (one with pem nut)
(Figure 6)
with new extender plate provide in the hardware
kit.
(Figure 7)
NOTE:
Make sure the plastic spacers are in place before assembling it.
6. Put back the screws to assemble both the clamp plates using T10 Torx Allen key.
(Figure 8)
NOTE:
Make sure the extender plate pem nut is facing out.
(Figure 9)
7. Repeat steps 3 to 6 for the other end of the clamp to replace the clamp plate with new extender plate.
8. Put back the clamps to tablet mount with T20 Torx Allen key.
9. After installation, the embossments outlined below are visible. Check by rotating the extension plate and ensure it
stops at the embossments.
Figure 8
Figure 9
