www.amico.com
16
Mounting the Basket (Optional)
WARNING:
DO NOT TIGHTEN ONE SCREW ALL THE WAY PRIOR TO INSERTING THE OTHERS. START BY INSERTING
ALL SCREWS HALF WAY, THEN TIGHTEN EACH SCREW INCREMENTALLY IN A CROSS PATTERN,
ENSURING THAT THE POST CLAMPS REMAIN PARALLEL. FAILURE TO DO SO MAY CAUSE DAMAGE TO
THE EQUIPMENT.
(Figure 2)
NOTE:
ROLL STAND BASKETS
are rated to support up to 10 lbs (4.54 kg).
1. Remove the
BASKET POLE CLAMP FRONT HALF
from the
BASKET POLE CLAMP BACK HALF
by unscrewing the four
REAR BASKET SCREWS
(BLACK), using a 1/2" (1.27 cm) Socket wrench.
(Figure 1)
2. Once at desired height (typically 2" [5.08 cm] below the
ROLL STAND BASKET
), place the
ROLL STAND POST
between
the front and back clamp halves and replace the screws using a 3/16" (47.6 mm) Hex key in a cross pattern.
(Figures 1 and 3)
Section 3: Assembly
Figure 2
HANDLE KIT SCREWS
[H-PHMS-1032-916]
(PART OF RS1-HANDLE)
2X
SMALLER PIECE OF
ROLL STAND HANDLE
[RS1-HANDLE]
STAND POST
[X-RS-POST-125]
LARGER PIECE OF
ROLL STAND HANDLE
[RS1-HANDLE]
INCORRECT
CORRECT
Correct
Incorrect
Tighten pattern
Figure 3
Figure 1
REAR BASKET SCREWS (BLACK)
[H-HSCS-1420-34]
(PART OF 100609-R125-BB)
4X
BASKET POLE CLAMP BACK HALF
[X-PC-125-2-8-32]
(PART OF 100609-R125-BB)
2X
BASKET POLE CLAMP FRONT HALF
[X-PC-125-1-8-32]
(PART OF 100609-R125-BB)
2X
STAND POST
[X-RS-POST-125]
2x
BASKET POLE CLAMP FRONT HALF
[X-PC-125-1-8-32]
4x
REAR BASKET SCREWS (BLACK)
[H-HSCS-1420-34]
(Part of 100609-R125-BB)
2x
BASKET POLE CLAMP BACK HALF
[X-PC-125-2-8-32]
(Part of 100609-R125-BB)
ROLL STAND POST
[X-RS-POST-125]
