INSTRUCTIONS FOR
FRONT HEADSTOCK STAND
MODEL NO:
FPS5.V2
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING!
Before use, ensure that there is nothing attached to the front forks, the fairing, or the rear end of the motorcycle, that
will foul the stand.
8
DO NOT
mount the stand on tarmacadam, as the surface may be unstable.
8
DO NOT
start the motorcycle when mounted on the stand.
8
DO NOT
sit on the motorcycle when mounted on the stand.
8
DO NOT
use the stand for a purpose it is not designed to perform.
8
DO NOT
operate the stand if it is damaged or parts are missing.
8
DO NOT
use the stand when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT
allow untrained persons to operate the stand.
8
DO NOT
make any modifications to the stand.
8
DO NOT
operate the stand if parts are missing or damaged.
9
Maintain the
stand in a good clean condition for the best and safest performance.
9
Locate the stand and motorcycle in a suitable area. Keep area clean, tidy and free from unrelated materials and ensure that there is
adequate lighting. Also ensure that the floor/ground is level and strong enough (preferably concrete) to take the weight of the stand
and the motorcycle.
9
Maintain correct balance and footing whilst positioning the motorcycle on the stand,
DO NOT
over reach.
9
Ensure that the floor is not slippery, wear non-slip footwear.
9
Keep children and unauthorised persons away from the work area.
9
Before loading or removing a motorcycle to/from the stand, ensure that there are no obstructions or persons around the motorcycle.
9
Always support bike to prevent falling.
9
Although the stand can be operated by one person, we advise seeking the assistance of a second person when mounting / dismounting
the stand.
9
Always use in conjunction with another suitable rear stand to ensure full stability.
9
When not in use, store in a safe, dry, childproof location.
WARNING:
The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations that may occur.
It must be understood that common sense and caution are factors which cannot be built into this product, but must be applied
by the operator.
2.
INTRODUCTION
Strong tubular frame supplied with a range of pins to fit the most common headstock sizes. Once in place, access to all mechanical
components at the front of the bike is made easily. Stand folds down for compact storage when not in use. Adjustable to suit different
head stock heights.
3. SPECIFICATION
Model No: ..................................................................... FPS5
Headstock Height ................................................ 830-925mm
Headstock Pin sizes ................................. 15,16,18,20,24mm
4. ASSEMBLY
4.1.
Refer to Parts List diagram.
4.2.
Ensure all fixings are correctly tightened and that frame members are securely fitted.
4.3.
Ensure all parts are present and in good order.
DO NOT
use parts other than those supplied.
FPS5.V2 Issue 1 03/04/18
Original Language Version
© Jack Sealey Limited
Refer to
instruction
manual
Wear protective
gloves
