Ametek LAND Genesis WDG-1200, User Manual

Page: 48 / 96

User Guide
Page 4 - 12
Genesis WDG-1200/1210
Insitu Oxygen Probes
Zero setting (AO
↵
ZEro)
To set the minimum O
2
concentration of the Analog Output
Range :
Press Enter
Select a value using the UP and DOWN keys
Press Enter again.
OPTIONS
Set zero reading output
RANGE
0 to 20 %
DEFAULT
0 %
Analog outputs span setting (AO
↵
SPAn)
To set the maximum O
2
concentration of the Analog Output
Range :
Press Enter
Select a value using the UP and DOWN keys
Press Enter again.
OPTIONS
Set span reading output
RANGE
1 % to 25 %
DEFAULT
20.90 %
Analog outputs damping setting (AO
↵
dPng)
To apply a smoothing facility for the output to stabilize the
reading under noisy signal conditions:
Press Enter
Select a value using the UP and DOWN keys
Press Enter again.
OPTIONS
Setting the damping rate
RANGE
0 to 999.0 sec
DEFAULT
10.00 sec
Base setting (AO
↵
bASE)
The output range required will determine the base selected.
Ranging from 0-10mA to 4-20mA. To make a selection:
Press Enter
Select the preferred option using the UP and DOWN keys
Press Enter again.
OPTIONS
[0-10][2-10][4-10]
[0-20][2-20][4-20]
RANGE
NOT APPLICABLE
DEFAULT
4-20
Outputs track setting (AO
↵
trAc)
The analog output can be set to “track” the O
2
levels or
“hold” the last reading during calibration. To set track or hold:
Press Enter
Select YES (track) or NO (hold) using the UP and DOWN keys
Press Enter again.
.
OPTIONS
[NO][YES]
RANGE
NOT APPLICABLE
DEFAULT
NO