Ametek 5100P, User Manual

Page: 17 / 83

PN 9000-246-VE, Rev D
Utilities Required for the Analyzer
• AC power connection, to charge the built-in Battery Pack (International
Power Adaptor supplied.)
Charging the 5100P Analyzer Battery Pack
The 5100P Analyzer is designed for battery operation, and it is important to en-
sure that its Battery Pack has been fully charged prior to using the analyzer.
To charge the Battery Pack:
Charge the 5100P Analyzer only in non-hazardous locations.
1. Connect the Battery Charger cord to the Charger Port on the back of the
5100P Analyzer. To do this, remove the Dust Cap from the Charger Port,
and align and insert the keyed/male-threaded charger connector end into
the Charger Port. See Figure 2-1. Tighten the connector finger tight.
Use only the AMETEK provided Battery Charger (PN 7001-874-SE),
110 VAC–250 VAC, 47–63 Hz, input 7.35 VDC, 2 A Output.
Figure 2-1.
5100P Battery Charger
connection port, dust cap on.
Battery Charger Port
(and Dust Cap)
USB Data Connection Port
(and Dust Cap)
Enclosure Vent
Sample Panel-to-Analyzer
Connecting Tube
Connecting and Starting Up the 5100P
|
2-3