L-Series and FCS-18 Graphical User Interface User Manual
2. Requirements
To successfully install and operate the LSGUI program, you will need the
following equipment :
L-Series AC power source. Supported models are :
751L 6000L
1501L 9000L
1503L 12000L
2000L 13500L
2750L 18000L
1
4500L
•
-P or -PT programmable controller. Manual controller (Type -M) equipped
L-Series AC sources can not be operated by this program. Contact
California Instruments for information on upgrading to a -P or -PT
controller.
•
PC capable of running Windows 3.1™, Windows for Workgroups 3.11™
or Windows 95™
•
National Instruments PC/IIA or PC-AT/TNT IEEE interface card. Other
vendor IEEE interface cards are not supported unless they are
compatible at the DLL level
2
.
•
IEEE
Cable
Note that the LSGUI can
be run in the absence of an
L-Series power source. If no
AC source is available or a
suitable IEEE controller card
cannot be found, the LSGUI
can be operated in a
simulation mode. The
program will detect these
conditions and start up in
simulation mode after n
be simulated and should not be used for any analytical purpose.
otifying the operator. Measurements in this case will
1
This model is not available at this time and is supported for future compatibility only.
2
DLL compatibility implies identical functional calls and parameters as the National Instruments GPIB.DLL.
Rev D – March 2011
California Instruments
11