AmeriWater 000-HS120, Operation & Maintenance Manual

Page: 37 / 79

35
098-0007 Rev B
Screen Example Screen Description
This button will appear when the tank maintain
mode has been toggled on AND the measured
tank temperature ≥ the disinfection set-point.
During Temperature maintain mode, the button
must be pressed to send hot water to the HD
machine. If the button is not pressed, the system
will continuously attempt to maintain the water at
the disinfection set-point temperature while
powered on.
Dispensing Mode Operation Screen
This screen will appear once the preheat mode is
completed. The current tank temperature, time
remaining for the water to be dispensed from the
tank, and the return flow rate will be displayed. If
the return flow monitor is disabled, the flow rate
will not be displayed and a message stating
“Return flow rate is not monitored” will be
displayed.
Abort
The abort button will send the user to an abort
confirmation screen. When the abort is confirmed,
the user will be sent back to the Home Screen.
The abort will be logged in the Alarm History Log.
Settings Menu
This screen is displayed if the user successfully
enters the “Level 1” password upon pressing the
settings button.
NOTE: Settings should only be adjusted by
properly trained personnel.
From this screen, the user can adjust the
disinfection temperature set point, expected heat
loss, temperature at which the heater shuts off
above the set point, and the maximum water
temperature. The defaults values for these
settings can be found in Section 7.6.
Diagnostics
Pressing the diagnostics button will prompt the
user to enter a “Level 2” password. Upon entering
the password, the user will gain access to the
diagnostics menu.
Alarm Menu
Pressing the alarm menu button will send the user
to the alarm menu where current alarms and
alarm history can be viewed.
SD Card Present