American-Lincoln Technology
3366XP / 4366XP
FORM NO. 56041668 -
7
OPERATION OF CONTROLS AND GAUGES
HYDRAULIC
SIGHT GLASS
P4696a
FIGURE 3
BROOM & FAN SWITCH (See Figure 2)
The broom and fan switch is located to the left of the right side broom lever. This switch “powers” the brooms and the vacuum fan
system. It has on-off positioning.
SHAKER MOTOR SWITCH (See Figure 2)
The shaker motor switch is located below the broom and fan switch. This is a momentary switch that will activate the
fi
lter shaker
motors. Hold the switch for 20 to 30 seconds to activate the shaker motors. When the shaker motors have been activated, the
brooms and impeller fan will stop. The shaker motors will only operate with the hopper in the “SWEEP” position. The switch is not
on the control panel if the machine is equipped with the CDC Dust Control Filter Option.
TIMED SHAKER MOTOR SWITCH (OPTION) (See Figure 2)
The shaker motor switch is located below the broom and fan switch. This is a momentary switch that will activate the
fi
lter shaker
motors for 20 to 30 seconds after it has been pushed. When the shaker motors have been activated, the brooms and impeller fan will
stop. The shaker motors will only operate with the hopper in the “SWEEP” position.
HYDRAULIC FLUID SIGHT GLASS (See Figure 3)
The sight glass is located on the side of the hydraulic oil reservoir.
The sight glass indicates the level of the hydraulic oil in the reservoir.
Fluid level must be visible in the sight glass when the hopper is in the down position. If the sight glass is completely full, then there is
too much
fl
uid in the reservoir.