American-Lincoln
Technology
3366XP / 4366XP
16
- FORM NO. 56041668
P4695
FIGURE
13
OPERATING INSTRUCTIONS
VIEW OF DRIVE PUMP FROM FRONT OF MACHINE
DRIVE
PUMP
TOW
VALVE
SHAFT
C0192
FIGURE 12
TOWING INSTRUCTIONS
1. Locate tow control shaft extension as shown in Figure
12. The tow control shaft is located underneath the
pump.
2. To open hydraulic circuit to wheel drive motor turn shaft
90°.
3. After towing, turn shaft 90° to its original position.
DUST FILTERS
The Filter Panel can be periodically removed from the hopper and blown off with compressed air (not to exceed 100 P.S.I.) or cleaned
with soap and water. (Do not attempt to use Filter Panels that have not dried completely.)
THE DUST CONTROL SYSTEM
The baf
fl
e system that is built into the debris hopper is designed minimize dust in the air while the machine is sweeping.
The debris from sweeping is thrown into the hopper. The impeller vacuum fan pulls the lighter dust up and through a baf
fl
e system.
The Pre-Clean Flap separates the heavier dust particles to an area below the
fi
lter. The lighter dust particles are captured by the dust
fi
lter. This allows the dust
fi
lter to remain cleaner and need less shaking to remove dust. When the dust
fi
lter becomes clogged the
fi
lter shaker switch should be pushed to start the dust shaker cycle. This will extend the life of the
fi
lter.
NOTE
The main broom and impellor fan will shut off automatically when the shaker motor is cycling.