American-Lincoln Technology
3366XP / 4366XP
FORM NO. 56041668 -
13
OPERATING INSTRUCTIONS
NOTE
Before starting the engine, perform these pre-start checks.
PRE-START CHECKLIST
1. Clean engine air
fi
lter element if needed
2. Check engine oil level
3. Check radiator coolant level
4. Check
hydraulic
fl
uid level
5. Check fuel level
6. Check all systems for leaks
7. Check brakes and controls for proper operation
BEFORE STARTING ENGINE
1. Set Parking Brake.
2. Make sure all controls are in the “Off” position.
TO START ENGINE
1. Be sure accelerator and directional control pedal is in neutral.
2. Turn key to “On” position & release.
3. If engine fails to start after following the above procedures, refer to Engine Manual.
NOTE
When machine has been stored in below-freezing temperatures, run engine at not over 1/2 throttle with machine standing still for 5 to 10
minutes to warm engine and hydraulic oil.
POST-START CHECKLIST (Engine Running)
1. Check main and side brooms to make sure they are free of debris which will inhibit rotation & pick-up.
NOTE: Always wear hand protection when cleaning debris from brooms and/or brushes.
2. Check squeegees to make sure there is no damage and they meet the
fl
oor.
TO OPERATE SWEEPER
1. Make sure parking brake is released.
2. Lower the side and main broom to the
fl
oor. (The main broom control may be placed in either the “FLOAT” or “SWEEP”
position.)
3. Turn Broom Fan Switch on.
4. Pull engine throttle to “UP” position. (Engine must always be operated at full governed speed while sweeping to obtain
recommended brush speed and dust control).
5. Push forward on directional control pedal to place machine in motion.
6. Vary your foot pressure on the directional control pedal to obtain desired travel speed.
TO STOP SWEEPER
1. Allow directional control pedal to return to neutral (centered) position. (Pedal will automatically return to neutral when
foot pressure is released.) FOR NORMAL OPERATION, DEPRESS DIRECTIONAL CONTROL PEDAL WITH HEEL INTO
NEUTRAL.
2. Depress the foot brake.
3. Turn Broom Fan Switch off.
4. Put the broom controls (Side and Main) in the “UP” position.
5. Push engine throttle down. Turn key to “OFF.”
6. Set parking brake.