450370 - 2
www.adclaundry.com
21
Data Label Information _______________
Data Label
When contacting ADC, certain information is required to ensure
proper service/parts information from ADC. This information is
on the data label affixed to the left side panel/wall area behind
the control door. When contacting ADC, please have the model
number and serial number available.
1. Model Number – This describes the style of dryer and
type of heat (gas, electric, or steam).
2. Serial Number – Allows the manufacturer to gather
information on your particular dryer.
3. Type Of Heat – This describes the type of heat for your
particular dryer, gas (either natural gas or L.P. gas),
electric, or steam.
4. Heat Input (For Gas Dryers) – This describes the heat
input in British thermal units per hour (Btu/hr) or kilowatts
(kW).
5. Orifice Size (For Gas Dryers) – Gives the number drill
size used.
6. Electric Service – This describes the voltage and current
rating for a particular model.
7. Gas Manifold Pressure (For Gas Dryers) – This describes
the manifold pressure taken at the gas valve tap.
Using A Manometer
HOW TO USE A MANOMETER
1. With dryer in nonoperating mode, remove plug on the gas
valve pressure tap.
2. Install 1/8” N.P.T. fitting supplied with the manometer.
3. Attach plastic tubing to pressure tap fitting.
4. Attach manometer to dryer using magnet.
NOTE:
Place manometer in a position so that readings can
be taken at eye level.
5. Fill manometer as shown in illustration to the zero level.
6. Start dryer. With burner on take a reading.
a. Read water level at the inner tube. Readings should
be taken at eye level.
b. Correct readings should be:
Natural Gas ___ 3.5 in WC (8.7 mb)
L.P. Gas ______ 10.5 in WC (26.1 mb)
7. If water column pressure is incorrect, refer to “To Adjust
Gas Pressure.”
8. Reverse procedure for removing manometer.
