14
American Dryer Corp.
450370 - 2
Front Support Rollers
TO REPLACE ROLLERS
1. Follow procedure “To Replace Front Panel Assembly”.
2. Use an Allen wrench to secure shoulder bolt at center of
roller.
3. Loosen and remove the nut at the back of the wheel
holding shoulder bolt in place.
4. Remove wheel.
5. Slide shoulder bolt out of wheel.
NOTE:
Do not lose brass wheel spacer.
6. Reverse procedure for installing new wheel.
Lint Drawer Screen
TO REPLACE LINT SCREEN
1. Open lint door and remove two screws holding lint screen
retainer in place.
2. Remove the lint screen and inspect for rips or tears by
sliding up and out of side tracks. Replace with new lint
screen, if damaged.
3. Reverse procedure for installing the new lint bag.
4. Close the lint door.
Motor
TO REPLACE DRIVE MOTOR
1. Discontinue power to the dryer.
2. Remove the drive belt.
3. Disconnect wiring harness from the motor.
4. Remove nuts and washers holding the motor mount to
the rear of the dryer and pull motor mount away.
5. Remove the bolts holding the motor to the motor mount
and replace it with a new motor.
6. Remove pulley from the old motor and install on the new
motor.
7. Replace motor mount to the dryer.
8. Align and tension belt.
TO REPLACE BLOWER MOTOR
1. Discontinue power to the dryer.
2. Disconnect wiring harness from the motor.
3. Remove nuts and washers holding the motor mount to
the rear of the dryer and pull motor mount away.
4. Remove the bolts holding the motor to the motor mount
and replace it with a new motor.
5. Replace motor mount to the dryer.