American DJ
®
- www.americandj.com - Vizi Spot LED PRO - Instruction Manual - Page 28
American DJ
®
- www.americandj.com - Vizi Spot LED PRO - Instruction Manual - Page 27
6. Press ENTER to confirm.
7. Press MODE/ESC to return to the main menu.
When you exit this function, the unit will begin to reload
data.
FEED
- With this function you can switch the Pan/Tilt error
correction on and off. This will automatically correct the
Pan/Tilt if it is somehow moved out of place.
1. Access the main menu.
2. Tap the UP button until “
SPEC
” is displayed, press ENTER.
3. Tap the UP button until “
FEED
” is displayed, press ENTER.
4. Press the UP or DOWN buttons to select either “
ON
” to acti-
vate this function, or “
OFF
” to deactivate this function.
5. Press ENTER to confirm.
6. Press MODE/ESC to return to the main menu.
FANS
-
With this function you can choose between the fan
settings of Low, High or Auto. The default setting is Auto.
1. Access the main menu by pressing MODE/ESC button.
2. Tap the UP button until “
FANS
” is displayed, press ENTER.
3. Press the UP or DOWN buttons to select either “
LOW
”, “
HIGH
”,
or “
AUTO
”.
4. Press ENTER to confirm your selection.
5. Press MODE/ESC to return to the main menu.
HIBE
-
With this function you can make the unit auto-
matically shut down the lamp and stepping motors. The
default setting for this is 15 mins. After 15 mins if the unit
Vizi Spot LED PRO
System Menu
If you want the set the address to 420, set Channel 1s’ value to
“7”, Channel 2s’ value to “8”, and Channel 3s to “164”. (256 +
164 = 420)
SPOT
- With this function you can adjust the LED via
the control board. The shutter opens and the LED can be
adjusted. In this mode, the device will not react to any con-
trol signal.
1. Access the main menu.
2. Tap the UP button until “
SPEC
” is displayed, press ENTER.
3. Tap the UP button until “
SPOT
” is displayed, press ENTER.
4. The display will show “
ON/OFF
”.
5. Press the UP button to select “
ON
” to activate this function,
or “
OFF
” to deactivate this function.
6. Press ENTER to confirm.
7. Press MODE/ESC to return to the main menu.
DFSE
- With this function you can restore the factory
settings of the device. All settings will be set back to the
default values. Any edited scenes will be lost. When restor-
ing the factory settings the unit must be set to the address
that the unit was in when you started editing.
1. Access the main menu.
2. Tap the UP button until “
SPEC
” is displayed, press ENTER.
3. Tap the UP button until “
DFSE
” is displayed, press ENTER.
4. The display will show “
ON/OFF
”.
5. Press the UP button to display “
ON
” to activate this function,
or “
OFF
” to deactivate this function.
Vizi Spot LED PRO
System Menu