American DJ
®
- www.americandj.com - Accu Spot Pro Instruction Manual Page 37
American DJ
®
- www.americandj.com - Accu Spot Pro Instruction Manual Page 38
02Er – TILT movement error:
If the head is not located in the default tilt position after start-
up or after a reset command. This message will appear after a
fixture reset, if the tilt magnetic-indexing circuit malfunctions
(sensor failed or magnet is missing) or there is a stepper motor
failure (defective motor or a defective motor IC drive on the
main PCB).
03Er - Color-wheel error:
If the color wheel is not located in the default position after
start-up or after a reset command. This message will appear
after a fixture reset, if the color wheel’s magnetic-indexing cir
-
cuit malfunctions (sensor failed or magnet is missing) or there is
a stepper motor failure (defective motor or a defective motor IC
drive on the main PCB).
04Er - Rotating gobo-wheel error:
If the gobo-wheel is not located in the default position after
start-up or after a reset command.This message will appear
after a fixture reset, if the gobo wheel’s magnetic-indexing cir
-
cuit malfunctions (sensor failed or magnet is missing) or there is
a stepper motor failure (defective motor or a defective motor IC
drive on the main PCB).
Accu Spot Pro
Error Codes
Operating Modes:
The Accu Spot Pro can operate in three dif-
ferent modes. This next section will detail the differences in the
operating modes.
• Stand alone mode -
The unit will react to sound, or chase through the built-in programs.
• Master/Slave mode -
You can daisy chain up to 16 units together to get a synchronized
light show
without the need of an external controller. The units
will
react to sound or chase through the built-in programs.
• DMX control mode -
This function will allow you to control
each individual fixtures traits
with a standard DMX-512 controller such as the Elation
®
Show
Designer.
™
Universal DMX Control:
This function allows you to use a uni-
versal DMX-512 controller such as the Elation
®
DMX Operator™ or
Elation
®
Show Designer™ to control head movement, the color wheel,
gobo wheel, prism, and the shutter (strobe). A DMX controller allows
you to create unique programs tailored to your individual needs.
NOTE: The Accu Spot Pro comes with a precaution mode incase
the DMX Signal is lost. Please see AUTO on pages 14 and 18 for
the different modes.
1. The Accu Spot Pro uses sixteen DMX channels. See pages 42-45
for detailed description of the DMX traits.
2. To control your fixture in DMX mode, follow the set-up procedures
on pages 10-12 as well as the set-up specifications that are
included with your DMX controller.
3. Use the controller’s faders to control the various DMX fixture traits.
4. This will allow you to create your own programs.
5. Follow the instruction on page 16 to set the DMX address.
6. For longer cable runs (more than a 100 feet) use a terminator on
the last fixture.
7. For help operating in DMX mode consult the manual included
with your DMX controller.
Stand-Alone (Sound Active or Auto Program):
This mode allows
a single unit to run to the beat of the music or run through a built-in
program.
Accu Spot Pro
Operation
