68
Setup NetCom Module sensor
Click
“Setup NetCom Module sensor”
tab on setup I/O port, you will the window as
Fig. 7-8.4.
Follow the instructions below to complete setting.
Step 1.
Choose a Sensor in pull-down menu. Enter location of specified sensor in
“Location”
box.
Step 2.
Choose sensor type (NC or NO) in
“Type”
box.
Step 3.
Select
“Enable recording”
and/or
“Enable snapshot”
and/or
“Enable sound alarm”
and/or
“Enable notification”
and/or “
Trigger speed dome
” and “
Enable TV out
”
configure their corresponding options to the right.
Enable recording:
select camera you want to record when emergency call is pressed.
Enable Snapshot:
select camera to snapshot when emergency call is pressed.
Enable sound alarm
: You can set each camera to have its own unique alarm sound.
For detail please refer
Chapter 7-4 of Software operation manual.
Enable notification
: See details on how to set up Notification in
Chapter 7-13 &
7-14 of Software operation manual.
Trigger speed dome
: See details on how to set up position in
Chapter 7-16 of
Software operation manual.
Enable TV out:
See details on Video Matrix out in
Chapter 7-18 of Software
operation manual.
Step 4.
Select the specific trigger relays to use from Relay 01 to 03(
Back Panel
). It also can
trigger the relays of each NC-180AZ module.
Step 5.
Enter ”
Post recording
” time to continue recording after sensor is triggered.
Step6.
Click “
OK”
to finish.
Emergency call
Click on
icon to set up “
I/O configuration
” tab, and you should see the
following window, as
Fig 7-8.1
. Upon pressing a panic button (hardware add-on), you can have
the emergency call feature sound an alarm, notify someone, start recording or show live video feeds
on linked TV sets.
Please follow the instructions below:" “
Emergency call
” is pressed; if you would have an alarm
sounded, notification sent to somebody, start to recording or show video on TV please follow the
instructions
Step 3-6 of Setup NetCom Module sensor
as the above.