9.
Reconnect any cables that were disconnected during installation and plug in
the computer's power cord.
10.
Turn on the monitor, and then your computer.
If you have properly installed your graphics card, operating system messages will
appear and the boot procedure will proceed.
Your monitor will be running in a basic (VGA) video mode. Higher refresh rates are
not available at this stage of the installation. Once you have installed the ATI
FireMV/ATI FirePro drivers and software, you can use
ATI Catalyst™ Control Center to adjust your video settings and configure multiple
monitors.
Proceed to install the software and drivers for your ATI FireMV/ATI FirePro
graphics card.
Baseplate Connections
The following figures show the display connections available on your graphics
card.
Note:
Baseplates may not appear exactly as depicted.
Figure 2–1 ATI FireMV 2400/ATI FirePro 2450 Baseplate Connections
1
VHDCI (Very High Density Connector Interface) Connection A
2
VHDCI Connection B
VHDCI Cable
Your ATI FireMV 2400/ATI FirePro 2450 card is designed for use with a pair of
VHDCI (Very High Density Connector Interface) cables, each of which provides
support for two monitors. The type of monitors supported depends on the cable
or adapters used.
6
Hardware Installation
ATI FireMV 2400/ATI FirePro 2450
©
2008
Advanced Micro Devices, Inc.
Summary of Contents for ATI FireMV 2400
Page 1: ...ATI FireMV 2400 ATI FirePro 2450 User Guide Part Number 137 50054 30...
Page 8: ...viii ATI FireMV 2400 ATI FirePro 2450 2008 Advanced Micro Devices Inc...
Page 18: ...10 Hardware Installation ATI FireMV 2400 ATI FirePro 2450 2008 Advanced Micro Devices Inc...
Page 38: ...30 Catalyst Control Panel ATI FireMV 2400 ATI FirePro 2450 2008 Advanced Micro Devices Inc...