AMC-UTx-M-xx-400 Series Digital Transmitter
44
Table 5-9: Transmitter Alarm Sub-Menu Settings
Menu Item
Description
Enable
Select this menu item to edit the alarm’s
enable state
Source
Select this menu item to edit the alarm’s
source (i.e. from the available sensors)
Input
Select this menu item to edit the alarm’s input
value
Level
Select this menu item to edit the alarm’s
setpoint
Type
Select this menu item to edit the alarm’s type
(increasing or decreasing)
Trigger
Select this menu item to edit the alarm’s
trigger output (i.e. activate which relays)
On Delay
Select this menu item to edit the alarm’s on
delay in terms of seconds
Off Delay
Select this menu item to edit the alarm’s off
delay in terms of seconds
Exit
Select this menu item to return to the Alarms
sub-menu.
If ‘Enable’ is activated from the alarm sub-menu, then the display will be updated to show the
following editing screen.
When the ENTER button is pressed, the confirmation screen (described previously) is displayed.
If
‘Source’ is activated from the alarm sub-menu, then the display will be updated to show the
following editing screen.
The available options for ‘Source’ is equal to the list of sensors currently configured for the UTx.
The label for each sensor is dynamically assigned to S<n> : <gas> where n represents the
sensor’s 1 base index and gas represents the sensor’s gas name in short form.
When the
ENTER
button is pressed, the screen will update to display the confirmation dialog
(described previously).
