ACN-ML
Version 1.3 / 3.48
ACN > MODE > RX
This is the corresponding receiver setting for the TX mode as
described above.
Note: in TX / RX record run timecode mode, no sync signal will be generated.
After switching from
OFF
to any of these 4 modes, you will be
redirected to pick an ACN channel from 11 through 26.
NOTE: all devices communicating via ACN need to be on the same channel AND firmware
version! You also can run different modes each on a dedicated channel on the set.
ACN > MODE = ON
After having picked an ACN channel for radio transmission, the ACN
menu will show several options.
ACN > CHNL
Lets you reconfigure the previously chosen transmission channel.
ACN > ANT
Lets you enable a
L
ow
N
oise
A
mplifier for enhanced range.
NOTE: This comes at the expense of backup battery life
ACN > PWR
PWR lets you increase the output power of the transmitter between 8
to 18dBm. For changes, a PIN is required.
©Ambient Recording GmbH 2015
22
