Cleaning, maintenance and repair
KG / KX / KE BAH0063-6 04.16
155
12.4
Changing the coulters (workshop work)
CAUTION
Coulters are made of hardened material. If you use a hammer for the
mounting/removal procedures, the ends may break off and cause
considerable injury.
CAUTION
Take special care when changing coulters. Do not turn the screws on
the square shaft.
Risk of injury from sharp edges.
1. Loosen the fastening nuts (Fig. 169/1).
2. Replace the worn coulters or adjust the
coulters for the operating conditions.
3. Tighten the fastening nuts (Fig. 169/1).
When changing the coulter, observe:
Mount the coulter parallel to the tool carrier
without a gap.
After 5 hours of use, check the bolt
connection for tight fit.
Fig. 169
12.5
Replacing the tension springs of the overload safety device (workshop
work)
CAUTION
The overload safety on the tines consists of tension springs that are
under high pretension. It is essential to use appropriate tools to install
and remove the tension springs.
Otherwise, there is a risk of injury.
