1.3.2 Setting up the ASD interface
The ASD interface can be used to transmit setpoints for
the application rate from a sensor To be able to use
these setpoints, the setpoints must be added to a job,
see page 62.
To set up the ASD interface, the baud rate for the data
transfer rate must be selected for the connected imple-
ment. The correct baud rate is written in the implement
operating manual.
Select
"Setup"
>
"Settings"
>
"Interfaces"
>
"AFD
baud rate"
.
Possible settings:
57600 baud
19200 baud
1.3.3 Adjusting the light bar
The light bar
1
shows the deviation of the tractor from
the guide track and thereby enables precise following of
the guide tracks.
014001
018888
G | Configuring the setup | Entering the settings
MG5560-EN-II
| B.1 | 2016.07
31
