4.
To change the increment length:
Select
.
5.
To shift the vehicle symbol up or down by a specific
distance:
Select
.
6.
To shift the vehicle symbol to the left or right by a
specific distance:
Select
.
7. Confirm the settings.
20
Using an external light bar
The light bar shows the track being followed.
The lower LED strip shows the deviation from the guide
track to the left or to the right.
The upper LED strip shows the steering angle required
to return to the guide track. If only the yellow LEDs are
lit, the implement is on the guide track.
20.1 Configuration menu
The light bar must have the same baud rate as the AMA-
TRON 3 and the GPS receiver. The light bar is set to a
baud rate of 19200 per default. The baud rate can be
changed in the light bar configuration menu.
1.
To change the baud rate of the light bar in the con‐
figuration menu,
press and hold
and switch on the AMATRON
3.
The upper LED strip shows the baud rate in the configu-
ration menu: baud rates 600 to 57600 increasing from
the left.
The lower LED strip shows the software version in the
configuration menu. Software version: x.x, x = 1-5 lit
LEDs).
021046
021072
K | Using the GPS switch| Using an external light bar
MG5560-EN-II
| B.1 | 2016.07
121
