1. Under
"Outer sections control mode"
, set the percent
value using the slide bar.
2. Confirm the settings with
.
2.1.2 Defining the overlap tolerance at the boundary line
The overlap tolerance at the boundary line defines how
far the outer sections can protrude over a boundary line
before they are switched off. Overlap tolerance at the
boundary line prevents the outer sections from being
constantly switched on and off when driving along and
touching a boundary line.
013552
P | Using part-width section control| Using automatic part-width section control
MG5574-
EN
-II | B.1 | 25.10.2016
190
