17
Rok-Bak
1. Close the valve on the propane cylinder, allow the
engine to stop and turn the machine OFF.
2. Remove the propane cylinder.
3. Raise the handle to the full-up position (about a 45°
angle).
4. Make sure the lid is tightened securely on the
solution tank.
5. Completely close the solution control valve.
6. (HD Models Only) Remove all weights from the
weight bracket (
See Weight Plates Section
).
7. Lift up on the front of the deck rocking the machine
back until it rests on the handle grips.
8. When lowering the machine down, do not drop the
machine. Slowly lower the machine to the floor until
the wheels are on the ground.
SafeStop
SafeStop is a system that monitors the fuel system
and stops engine operation if either an overfilled
cylinder or liquid draw cylinder is used. If SafeStop
is activated, the red LED will illuminate and the
engine will stop operating. If this occurs, remove the
cylinder from the machine, take the cylinder outside,
and verify it is a properly filled vapor draw cylinder.
Note: This system is not a substitute for properly
inspecting propane cylinders prior to bringing inside
a facility. Overfilled or liquid draw cylinders can
damage the fuel system and create a fire hazard.
Refer to the Safety Precautions section in this
manual.
Wheel Adjustment
1. Place the machine in the Rok-Bak position. (see
Rok-
Bak
section)
2. Locate the wheel brackets on the underside of the
underside of the machine.
3. Remove the pin that retains each wheel and relocate
to the desired wheel position.
4. Place the wheels in either the “B” (Burnishing - High
Speed) or “G” (Grinding - Low Speed) position,
depending on what function you are using the
machine for.
NOTE
: There are two different settings for each
function. To increase pad pressure (more aggressive)
move wheels to rear of machine. To decrease pad
pressure (less aggressive) move wheels toward the
front of machine.
CAUTION!
Always place the wheels in the same
corresponding location on both wheel brackets.
Failure to do so could damage the floor and/or the
machine.
Summary of Contents for Pioneer Eclipse PE420GP Series
