31
Belt Replacement
Part #: MP8080
1. Follow steps 1 through 11 under the “
Inspect Pads,
Pad Holders, & Drivers”
secton.
2. Using a straight screw driver and a 3/8” wrench,
remove the screws retaining the shroud liner.
Remove the liner.
3. Using a 3/8” wrench, remove nut retaining solution
fitting in liner.
4. Use a large flat screwdriver, between the belt and the
spindle pulley, to pry the belt off of the spindle pulley.
5. Use the 3/4” wrench to turn the end of the spindle
shaft on top of the machine while removing the old
belt from the spindle pulley.
6. Finish removing the belt from the clutch pulley, if
necessary.
7. Check clutch pulley for correct alignment with the
spindle pulley. Check hardware attaching pulleys for
proper tightness.
8. Install the new belt onto the clutch pulley.
9. Reinstall the new belt onto the spindle pulley using
the 3/4” wrench to turn the spindle clockwise. Make
sure the belt is correctly placed on the idler pulley.
10. Attach the solution fitting to the liner with a 3/8”
wrench.
11. Attach the shroud liner with a screw driver and a 3/8”
wrench.
12. Reinstall the pad holder onto the spindle shaft.
13. Lower the machine to the operating position.
14. Check belt for correct operation. Check all hardware
for proper tightness.
Summary of Contents for Pioneer Eclipse PE420GP Series
