30
Inspect Pads, Pad Holders, & Drivers
1. Push machine to level surface.
2. Turn off LP cylinder and remove it.
3. Make sure the lid is tightened securely on the
solution tank.
4. Completely close the solution control valve.
5. On “HD” models, be sure to remove all of the weights
from the weight bracket.
6. Place the machine in the Rok-Bak position. (see
Rok-
Bak & Pad Change
section)
7. Remove centering device and inspect the pad. If
the burnishing or diamond impregnated pad has
worn less than 1/4” (6 mm), replace it. If the Level-S
rubber diamond pads have worn to less than 1/16”
(1.6mm), replace it.
8. Inspect the Level-S adapter pad. If the pad is torn or
has started to delaminate, replace it.
9. Inspect the pad holder or driver for cracks or
damage. If the pad holder does not have any
damage proceed to step 13.
WARNING!
A damaged pad holder or driver rotating
at a high rate of speed may be an extreme hazard if it
should come apart.
10. If the pad holder needs to be removed, a 3/4” wrench
will be required. Locate the wrench flats on top of
the spindle shaft. With the spindle shaft secure, turn
the pad holder counter clockwise until it is free of the
spindle shaft.
11. Save the washer and/or spacer that is on the spindle
shaft. Be sure they are in place when the pad holder
or driver is re-installed.
12. When threading the pad holder or driver onto the
spindle shaft, use the wrench to keep the shaft from
turning. Be sure the pad holder or driver is tight
before proceeding.
13. Secure the new pad with the centering device.
14. Gently, lower the machine back to the operating
position.
Belt Maintenance
1. Push machine to level surface.
2. Turn off LP cylinder and remove it.
3. Make sure the lid is tightened securely on the
solution tank.
4. Completely close the solution control valve.
5. On “HD” models, be sure to remove all of the weights
from the weight bracket.
6. Place the machine in the Rok-Bak position. (see
Rok-
Bak & Pad Change
section)
7. Rotate the pad holder or driver and inspect the belt.
8. If cracks or excessive wear is present, the belt needs
to be replaced. (see
Belt Replacment
section)
9. To check for the proper tightness, squeeze the belt
together. The belt should depress between 1/4” (0.6
cm) and 1/2” (1.3 cm).
Summary of Contents for Pioneer Eclipse PE420GP Series
