－１９－
５．
OPERATION
！
WARNING
・
To avoid FIRE or EXPLOSION: Do not draw in the following substances.
・
Explosive, flammable substances
…………
Aluminum, magnesium, titanium, epoxy, organic solvent, etc.
・
Inflammable substances
…………
Gasoline, thinner, benzene, kerosene, paint, etc.
・
Dust with sparks
……………
Dust produced by a high speed cutter, grinder, welding machine, etc.
・
Source of fire
…………………
Cigarette butts, ashes, etc.
・
Other
………………
Water, chemical and oil with a low flash point (below 80°C)
・
Never operate the mist collector in or near an area where inflammable, explosive or
corrosive mist, fumes or gases are present.
These gases could cause fires or explosions.
・
To avoid FIRE or EXPLOSION: Do not install in a hazardous area ruled by law or
regulation in your country.
・
If a fire occurs or there is a dust explosion inside the mist collector,
・
turn off the power immediately.
・
use a fire extinguishing agent suitable for dust.
・
even after the fire is out, don’t open the door until the internal temperature drops to the normal level.
Otherwise, a secondary explosion could occur.
！
CAUTION
・
To avoid MALFUNCTIONS, ELECTRIC SHOCK, or FIRE:
Turn off the power immediately if there is smoke, vibration, or unusual noise or odor
during operation.
・
Do not operate the unit with its inlet and outlet holes covered.
Neglecting this caution could cause overheat resulting in occurrence of fire.
・
To avoid EYE INJURY or other SERIOUS PERSONAL INJURY from expelled
particles or droplets: Do not look into the exhaust outlet!
・
To avoid PERSONAL INJURY: Always wear gloves during inspections and when
replacing parts.
・
If the motor stops during operation, turn off the primary power at once.
Failure to do this could cause electric shock.
・
Keep the intake air temperature between 5 and 50°C.
Failure to do so can cause accidents or malfunctions.
・
Do not take in the combustible mist with a flash point of 80°C and under.
・
This machine should only be used for collecting the mist from machining operations.
