LEVIGATO DRIVES (LG SERIES)
|
LEVIGATO ANTRIEBE (SERIE LG)
|
COMMANDES LEVIGATO (SERIE LG)
22
ADjUSTMENT
SETTING P1–f3: express-setup of the end positions and radio control setup
The end
OPEN
and
CLOSED
positions are set automatically with a switch to the recording of
remote controls in the programming mode
P2
–
f1
(
tab
. 9).
Y
ATTENTION!
Make sure that a support is installed on the rail for the
OPEN
position (
fig.
16).
1
Simultaneously press and hold the buttons
and
for 5 secs.
ATTENTION!
Automatic movement of the door begins immediately. Watch
the movement of doors. The automatic setting can be stopped with pressing
any button on the drive panel.
Note: the express-setup procedure can be started similarly, if the mode ‘
P1
’ and
the setting ‘
f3
’ are selected
2
The door automatically moves to the contact point between the carriage rail
and the support, and a dot appears on the display
3
The door automatically moves to the
CLOSED
position. Movement continues
to the upper panel support, and after that a dot appears on the display
4
The door automatically moves to the
OPEN
position
5
The door automatically moves to the
CLOSED
position
6
‘
rc
’ is shown on the display, which means that the recording of remote controls
in ‘
step
-
by
-
step
’ mode is expected
7
Press the selected control button on the remote control three times
8
The indicator will automatically show the number offered for a remote control in
the drive memory (the number can be changed using the buttons
or
)
9
Press the button
to confirm; after that a dot will appear on the display
10
In three seconds the automatic switch to the recording of the next remote control
will take place. To exit the programming mode press the button
three
times or wait for 15 seconds
SETTING P1–f2: setting the ‘pedestrian position’ / partial opening
The
PEDESTRIAN
position can only be set from the remote control board, recorded with this
control mode (menu
P2
mode
PE
). The
PEDESTRIAN
position can be set from any position of
door (end or intermediate position).
Table 7
