LEVIGATO DRIVES (LG SERIES)
|
LEVIGATO ANTRIEBE (SERIE LG)
|
COMMANDES LEVIGATO (SERIE LG)
21
ADjUSTMENT
6.1
ADjUSTMENT Of THE DOOR POSITION
The end
OPEN
and
CLOSED
positions are set manually (setting
P1
–
f1
) or automatically (Ex-
press setup
P1
–
f3
with a switch to the recording of remote controls). If the end positions are
not set, the drive does not execute a commands, and two dots will appear on the display
.
Y
After the end positions are set,
P5
and
P6
menu settings are automatically reset to the factory
default values (
table 16
).
SETTING P1–f1: programming the end positions manually
1
Press and hold the button
for about 5 secs to enter the
programming mode
2
After the appearance of ‘
P1
’
inscription press the button
3
After the appearance of ‘
f1
’
inscription press the button
4
Using the button
or
set the door in the
OPEN
position.
ATTENTION!
In the OPEN position the carriage rail should be at a distance
20 mm from the support; installation of support is compulsory (
fig.
16)
5
Press the button
; after that a dot will appear on the display, which
means the
OPEN
position
6
Using the button
or
set the door in the
CLOSED
position.
ATTENTION!
Avoid excessive pressing of the door leaf against the doorway in
the
CLOSED
position. After programming the end positions, the force required
for the manual release (section 4.2. ‘Manual release’) must not be more then
220 Н
7
Press the button
; after that a dot will appear on the display, which
means the
CLOSED
position.
ATTENTION!
Automatic movement of the door begins immediately
8
The door automatically moves to the
OPEN
position
9
The door automatically moves to the point of contact
10
The door automatically returns to the
OPEN
position
11
The door automatically returns to the
CLOSED
position
12
After completion of all positional settings of the door, ‘
f1
’ inscription will
appear; to exit the setup menu press twice the button
or wait for
15 seconds
Table 6