1
2
MOUNTING THE CROSS-CONNECTOR
MOUNTING TRUSS PROFILES IN A LATTICE ARRANGEMENT
HORIZONTAL MODULE ARRANGEMENT
MOUNTING THE ‘BASIS RAIL’ TRUSS PROFILE
4
h
CONNECT THE TRUSS PROFILES
Necessary when the width of the module field is greater than the length of
the truss profile.
Push the profile connector halfway into the first truss profile, then connect
the second truss profile to the profile connector.
MOUNTING TRUSS PROFILES IN A LATTICE ARRANGEMENT
Mount the
‘Basis Rail’
truss profile horizontally, parallel to the ridge of the
roof with the correct side up, and tighten to a torque of
15Nm
.
Rotate the cross-connector into the
‘basic rail’
and tighten to a torque of
15Nm
.
Please note:
If the
‘Basis Rail’
profiles are mounted vertically, parallel
to the side ends of the roof, the truss profile fixing screw on the cross-
connector should always be pointing in the direction of the roof ridge.
Mount the
‘Module Rail’
truss profile vertically on the cross-connector,
parallel to the side edges of the roof with the correct side up, and tighten
to a torque of
15Nm
.
3
MOUNTING THE ‘MODULE RAIL’
TRUSS PROFILE
Top
Bottom
15
Summary of Contents for AS 2.1
Page 1: ...TILED ROOFS AS 2 1 EN SOLAR INSTALLATION INSTRUCTIONS 1 ...
Page 6: ...MOUNTING WITH ROOF HOOKS VERTICAL MODULE ARRANGEMENT SINGLE DIRECTION 6 ...
Page 14: ...MOUNTING TRUSS PROFILES IN A LATTICE ARRANGEMENT HORIZONTAL MODULE ARRANGEMENT 14 ...
Page 18: ...MOUNTING WITH AL13 X ROOF HOOKS VERTICAL MODULE ARRANGEMENT LATTICE 18 ...