ALUMERO AS 2.1, Installation Instructions Manual

Page: 10 / 28

1
2
MOUNTING BEAVER TAIL ROOF HOOKS
Modules must only be clamped in the sections prescribed for attach-
ment . These can be found by consulting the manufacturer’s respective
module data sheet.
Module clamping ar
ea
Symbolbild
MOUNTING BEAVER TAIL ROOF HOOKS
MEASURE AND MARK POSITIONS
Measure and mark the positions of the roof hooks on the roof using the
Solar.Pro.Tool project report and remove the roof tiles above the rafter.
The tile below the roof hook should be replaced with a sheet metal tile.
Attach the hook with
2 plate head screws driven into the rafter.
Replace the previously-removed roof tile correctly. Make sure the roof re-
mains entirely watertight.
Please note:
- The gap between the edge of the plate head screw and the end of the
rafter must be at
least 24mm
.
- The plate head screw must be inserted to a
depth of at least 60mm
.
- Ideally recommended for roofs with
rafters at least 80mm
across,
and at least 60mm
- It is necessary to pre-drill holes into the wooden substructure when
using wood screws.
- We recommend that roofing tasks should only be carried out by pro-
fessional roof contractors.
10