Altrad BELLE PREMIER 100XT, Operator'S Manual

Page: 20 / 70

20
Mixing Hints GB
Mix Ratios
7KHFRUUHFWPL[UDWLRFHPHQWVDQGVWRQHGHSHQGVRQWKHW\SHRIDSSOLFDWLRQKDUGHUFRQFUHWHUHTXLUHVPRUHFHPHQWURXJKHU
DSSOLFDWLRQVUHTXLUHPRUHDJJUHJDWH7KHUDWLRVJLYHQEHORZDUHJXLGHOLQHVEHVWSURSRUWLRQVPD\GHSHQGRQWKHTXDOLW\RIVDQGVWRQH
used.
First put in the water - around 7 litres (1½ gallons), using more or less depending on the type of mix required. Add some aggregate
before adding cement, to avoid sticking. Work consistently to the ratio of ingredients for whatever type of concrete mix you are
working to.
Getting A Good Mix
The approximate mixing time for concrete is 2-4 minutes from when all the material (including the water) has been added - over-
mixing can reduce strength and cause segregation of the coarser aggregates.
Beware of low grade aggregates; these will only lead to trouble later on with sinking and frost spoiling the appearance of the pour.
Also do not get the concrete mix too wet as this can reduce strength and make it less able to withstand weathering.
Looking After Your Mixer
1HYHUWKURZPDWHULDOLQWRWKHPL[HUWULFNOHLWVWHDGLO\RYHUWKHULPRULWZLOOVWLFN¿UPO\WRWKHEDFNRIWKHGUXPDQGFDQRQO\EH
dislodged by stopping the mixer.
Keep your mixer clean - material left in the drum will harden, and attract more on each use until the mixer is useless.
Do not throw bricks into a mixer drum to clean it out. The best method is a mix of 1” (2½cm) gravel and clean water - use plenty of it,
as this will do the job in half the time.
APPLICATIONS QUANTITIES
CEMENT SAND STONE
MOST ORDINARY 1 2 4
FOUNDATIONS 1 3 6
ROUGH MASS CONCRETE 1 4 8
WATERTIGHT FLOORS,TANKS PITS ETC. 1 1.5 3