Altendorf WA 6, Operating Manual

Page: 54 / 76

Operating
54
Operating
0000010064-007- GB
7.5.2 Tilt adjustment
7.5.3 Changing the main saw blade
Please note that only saw blades with side holes (2 holes 10 mm ø at a spacing
of 60 mm) can be fitted. This is necessary to prevent loosening of the saw
blade mounting in the course of braking!
• Undo the clamping
• Turn the hand wheel
• The pivot angle is displayed at the centre of the hand
wheel
• Tighten the clamping
WARNING!
Always observe the following points prior to pivoting the saw blade:
• Remove the workpieces located in the pivot section from the table.
• When cutting widths < 130 mm, place the rip fence straight edge to flat
position.
WARNING!
The following points must always be observed:
Non-adherence may lead to severe injuries!
• Do not fit any saw blades that are cracked or damaged in any way.
• Only fit saw blades with a diameter between 250 and 315 mm