Altendorf WA 6, Operating Manual

Page: 48 / 76

Operating
48
Operating
0000010064-007- GB
7.1.3 Cutting on the manually adjustable rip fence
Practical examples
Function overview
• 2 stop fence settings
• Infinitely variable positioning of the fence
• Infinitely variable dimension setting up to a cutting width
of 1000 mm
Dimension setting
• Release the clamping (1)
• Set the rip fence to the required dimension
• Tighten the clamping (1)
The dimension scale can be adjusted to the individual tool
thickness after releasing the knurled screw (2).
Stop fence position
• Release the clamping (3)
• Pull out the stop fence (4) to remove it
• Turn the stop fence by 90°
• Push the stop fence into position
• Tighten the clamping (3)
WARNING!
Danger of injury!
When cutting widths of less than 120 mm, ensure that the material is fed with a
push stick and that the stop fence is laid flat.
Machining short workpieces
• The operator pushes the workpiece against the stop pro
-
file and the workpiece is fed either using the sliding table
or the guide on the stop profile, depending on the work
-
piece.
Machining of flat and narrow workpieces
• The operator pushes the workpiece against the stop pro
-
file and the workpiece is fed using the sliding table