Altendorf WA 6, Operating Manual

Page: 44 / 76

Installation
44
Installation
0000010064-007- GB
6.4.7 0° setting of the saw blade
Checking the 0° position of the saw blade
• Set the tilt adjustment to 0°.
• Set the saw blade to the maximum cutting height
• Position 2 strips of approx. 100 x 400 mm upright on the
crosscut-mitre fence and cut off a narrow piece
• Hold the cut surfaces against each other and check that
they are parallel
• If the setting is correct, the cut surfaces should be paral
-
lel, i.e. no gap can be seen between the cut surfaces
Setting the 0° position of the saw blade
• Undo the lock nut (1)
• Adjust the screw (2)
• Tighten the lock nut (1)