Altendorf WA 6, Operating Manual

Page: 34 / 76

Installation
34
Installation
0000010064-007- GB
6.3.5 Cross slide and crosscut-mitre fence
6.3.6 Sliding table
• Place the bottom carriage on the machine frame and use a special wrench
to tighten the outer fastening screws Push against the stop screws prior to
tightening.
• Place the middle carriage on the bottom carriage so that the interlock is
pointing to the right.
• Push the middle carriage up to the stop.
• Carefully push the top carriage onto this set-up. Ensure that the sliding
table does not jam and the guide rods are carefully pushed onto the double
rollers.
• Push the top carriage towards the left, all the way to the stop.
• Fit the back stop. Check whether the stop on the top carriage and the stop
on the bottom carriage hit the end position at the same time and re-align, if
necessary.
• Prior to start up, check the setting of the sub-rollers.
• Position the supporting pipe (1) of the cross slide (2) on
the bolt (3) of the telescopic tube (4)
• Attach the cross slide to any point of the sliding table (5)
and use the eccentric lever (6) to clamp it
• Position the crosscut-mitre fence (7) on the cross slide
• Attach and tighten all clamping screws (8)