PAGE 61
ALMAC s.r.l.
2.9
Safety indications on the use of the travel function
2.9.1
General indications
You must follow the instructions given below:
•
It is forbidden to drive on roads open to traffic; the machine is not approved for this purpose;
•
Make sure that the movement manoeuvres take place on flat and firm terrain;
•
Make sure that there are no hollows or ridges in the floor and that there is enough room for
the machine to pass through;
•
Make sure that there are no bystanders or obstructions in the surrounding area before moving
off;
•
Do not CHANGE DIRECTION on kerbs, rocks or appreciable differences in level (> 10 cm) when
driving the machine. In this case, always proceed perpendicularly to the obstacles;
•
If you must drive up a slope, do not change direction when the ground changes from flat to
sloping. If this is absolutely necessary, perform the manoeuvre gradually.
•
Do not drive along the edge of slopes or over uneven ground with one track horizontal and the
other slanting or partially raised (>10°) as this will damage the tracks.
ALWAYS PROCEED
WITH THE TRACKS RESTING ON THE SAME HORIZONTAL PLANE
.
•
Driving over an obstacle creates a gap between the bearing rollers and track, which could
consequently slip out of its housing.
•
If you change direction in a situation where the track could move sideways owing to an
obstruction, the track could slip out of its housing.
•
Check to make sure that there are no bystanders near moving parts when the platform is
lowered.
Summary of Contents for AlmaCrawler JIBBI 1250 EVO
