ALMAC AlmaCrawler JIBBI 1250 EVO, Translation Of Original Instructions, Page: 52 / 233

PAGE 52 ALMAC s.r.l.
Nominal voltage (kV) Minimum distance (m / ft)
≤ 1 3 / 9.84
1 < Un ≤ 30 3.5 / 11.48
30 < Un ≤ 132 5 / 16.4
> 132 7 / 22.96
•
Do not use the machine during storms. You could be struck by lightning;
•
It is forbidden to use the machine if the wind speed exceeds 12.5 m/s.;
•
Use the MEWP only within the permitted temperature range;
•
It is forbidden to use the platform on soft, slippery or unstable;
Type of terrain, geomorphological
characteristics
Permitted surface pressure
Loose non-compact soil In general, not solid; requirement for
particular measures.
Mixed, compact soil, sand and gravel 2.0 kg/cm² 0.2 N/mm²
Semi-solid cohesive soil 1.0 Kg/cm² 0.1 N/mm²
Solid cohesive soil 2.0 Kg/cm² 0.2 N/mm²
Hard cohesive soil 4.0 Kg/cm² 0.4 N/mm²
Rock, concrete, road paving suited to the
transit of heavy vehicles Over 10.0 Kg/cm² over 1 N/mm²
•
Never open the engine compartment without having previously removed the power supply from
the control panel on the ground;
•
In the work area below the platform, there must be no causes of obstacle or danger in case of
descent of the platform;
•
Ensure and, if necessary, prevent persons from standing in the area below the platform work
area;
•
Before getting into the basket, ensure horizontality of the same; correct the balance using the
appropriate controls;
•
An operator must not accept operational responsibilities until adequate training has been given
to them by authorised and competent personnel;
•
Before operation, check that there are no suspended power lines in the work area, other
machines such as bridge cranes, road and track machines and construction equipment. Ensure
that operators of other aerial machines or on the ground are aware of the presence of the
platform. Remove tension from aerial cranes, place obstacles on the ground if necessary;
•
Before starting work, the operator and their supervisor must take the necessary precautions
in order to avoid the known dangers;
•
Only operate the machine after having carried out the maintenance operations in accordance
with the specifications and the deadlines indicated by the manufacturer;
•
Never work with a machine in poor operating conditions; if a fault occurs, stop the machine,
affix a clearly visible sign and inform the relevant personnel;