ALMAC AlmaCrawler JIBBI 1250 EVO, Translation Of Original Instructions, Page: 184 / 233

PAGE 184 ALMAC s.r.l.
GREASES TABLE
(The grease normally used by the manufacturer is PAKELO)
Grease
°C -10 / 40
PAKELO BEARING EP GREASE NLGI2
BP GREASE LTX2
CASTROL LM2 - SPEEROL APT2
SHELL ALVANIA GR.R.2
ESSO BEACON 2
SMALL VALVES LITHIUM 20
ELF TRASLUBE LI GREASE 2
6.4.9 Checking the tracks for wear
Check the wear and condition of the tracks, replacing them when the tread is equal to or less than
10 mm.
The tracks must be changed even before they reach this limit if they are cuts or tears are noted.
Attention : Tracks must only be replaced by specialized, properly trained personnel.
6.4.10 Replacing the tracks
Attention : It is forbidden to open the gear unit for any operation that is not included in ordinary
maintenance. The manufacturer shall not be held responsible for any operations not included in
scheduled maintenance that have caused damage to property and/or harmed people.
Attention : USE PERSONAL PROTECTIVE DEVICES.
The track must be replaced when 10 mm of tread is left or even earlier if there are any cuts.
Proceed as follows:
1) Using a forklift or other lifting equipment (see previous chapters) lift the machine off the
ground (15-20 cm will be sufficient);
Attention : Make sure the machine is stable.
2) Thoroughly clean all parts of the tracked undercarriage;
3) Remove the lateral cover of the tracked undercarriage frame (1);
4) Remove the mechanical stop located inside the tracked chassis (2);