ALMAC AlmaCrawler JIBBI 1250 EVO, Translation Of Original Instructions

Page: 56 / 233

PAGE 56 ALMAC s.r.l.
The following drawing shows the maximum height of the aerial part in transport configuration.
If both tracks are completely extended, the column can be freely r-110° and the machine
is always in transport condition;
If only one track is fully extended, rotation will only be permitted on its side;
If both tracks are not completely extended then the column must be completely centred (+-2°);
If however, in this condition, the basket is not mounted on its support then the column will be
able to rotate by +-45° (use this function to be able to move in areas with limited room for
manoeuvre).
Attention : This procedure can also be performed with the operator not in the basket.
In this case, the length of the connecting cable is sufficient to allow the operator to remain at a
safe distance from the machine.
Attention: Crushing hazard!
Function 1 (optional): The machine has an advanced traction control function, which is used to
advance and steer via the action on the right joystick only. It is advisable to use this mode of
operation with the platform in the maximum track configuration, after alignment with the ramps.
To activate it, simply press the button (11) of the push-button panel.
The function remains active until the button is pressed again or the machine is switched off or on
again via a key or emergency stop.
When the function is selected the word "FAST DRIVE" will appear on the Display.
Attention: Also make sure that the display shows the wording “Booster OFF”. To deactivate the
booster simply keep the potentiometer below 90%; it is advisable to position it between 50 and
70%.
Function 2:
The machine has an advanced function that allows automatic lifting of the telescopic
boom if its angle is between 0 and 5°.
20°
-75°
L
M
S=0
mm