ALMAC AlmaCrawler JIBBI 1250 EVO, Translation Of Original Instructions

Page: 170 / 233

PAGE 170 ALMAC s.r.l.
place and that there is no damage
and/or leakage;
•
Check that the hand pump and the
diverter for emergency manoeuvres are
tightened into place and do not show
signs of damage and/or leakage;
•
Check that the sliding blocks of the
outreaches are tightened in place and
do not show signs of visible damage;
•
Check that the outreach extension and
retraction chains are in position, are
properly tensioned and exhibit no visible
damage;
•
Check that the basket is locked in place
and is not damaged;
•
Check that the control console and its
support are locked in place and that no
damage has occurred;
•
Check that all the sensors in the
machine are locked in place and do not
show any signs of damage;
•
Check the condition of the safety
stickers, that they are in place and that
they do not show visible signs of
damage;
•
Check that no cracks or rust are visible
in the structure.
•
Perform rotation of the column in both
directions and make sure that the machine
works correctly. No load must be present on
the platform;
•
Check the operation of the translation
function with platform raised; this test is
performed by lifting the platform to a height
that involves a corner of the main boom
being between 20° and 70° to the horizontal
and check that it is possible to move with the
machine only at reduced speed;
•
Check that with the platform lifted higher
than the transport height but lower than the
maximum travel height and moving on non-
level
terrain, the machine stops
automatically when the inclination of the
frame with respect to the horizontal exceeds
1°. Release the travel control; when this
control is operated again or when the lifting
control is operated, the system must bring
the frame back to the horizontal position
automatically. After the levelling, the
machine will
perform the selected
movement;
•
Lift the platform to a height greater than the
transport height, check that the manual
levelling functions are not permitted;
•
Operate the emergency button on the
remote control (or radio control); make sure
that the engine turns off (both the internal
combustion engine and the electrical engine)
and that no functions are allowed. Release
the mushroom-shaped button after this test;
•
Operate the ground movement emergency
button; make sure that the engine turns off
(both the internal combustion engine and
the electrical engine) and that no functions
are allowed. Release the mushroom-shaped
button after this test;
•
Press the emergency button on the basket
support (if applicable), check that the
engine (both endothermic and electric) is
switched off and that no function is
permitted. Release the mushroom-shaped
button after this test;
•
Operate the warning buzzer and make sure
it works;
•
Check the operation of the buzzer when the
drive function is activated;