ALL126AS3
USER’S MANUAL
214
Appendix E:
Troubleshooting
Diagnosing the Router
’s Indicators
The router can be easily monitored through its comprehensive panel indicators. These indicators assist the network
manager in identifying problems the hub may encounter. This section describes common problems you may encounter
and possible solutions.
1. Symptom:
POWER indicator does not light up (green) after power on.
Cause:
Defective External power supply
Solution:
Check the power plug by plugging in another that is functioning properly. Check the power cord with
another device. Check the terminal block make sure to fasten the power cord.
If these measures fail
to resolve the problem, have the unit power supply replaced by a qualified distributor.
Note:
Please refer to power status table to check power input status. Section 3.3
2. Symptom:
Link indicator does not light up (green) after making a connection.
Cause:
Network interface (ex. a network adapter card on the attached device), network cable, or switch port
is defective.
Solution:
2.1 Power off and re-power on the VDSL2 router.
2.2 Verify that the switch and attached device are power on.
2.3 Be sure the cable is plugged into both the switch and corresponding device.
2.4 Verify that the proper cable type is used and its length does not exceed specified limits.
2.5 Check the router on the attached device and cable connections for possible defects.
2.6 Make sure that the phone wire must be connecting ALL126AS3 first, when powered on.
Summary of Contents for ALL126AS3
