ALL126AS3
USER’S MANUAL
205
Figure A-3 Pin Assignments and Wiring for an RJ-45 Crossover Cable
A.2 Telephone wire
Standard telephone wire of any gauge or type-flat, twisted or quad is used to connect the Modem to the telephone network. A
telephone cable typically consists of three pairs of wires, one of which is used for transmission. The connector at the end of
the telephone cable is called an RJ-11 connector and it consists of six pins. POTS (plain old telephone services) use pins 3
and 4 for voice transmission. A telephone cable is shown below. (
Figure A-4
)
A
B
Figure A-4 Telephone cable
The A and B connectors on the rear of the Modem are RJ-11 connectors. These connectors are wired identically. The RJ-11
connectors have six positions, two of which are wired. The Modem uses the center two pins. The pin out assignment for
these connectors is presented below. (
Table A-2
)
Table A-2
RJ-11 Pin out Assignments
Pin#
MNEMONIC
FUNCTION
1
NC
Unused
2
NC
Unused
3
TIP
POTS
4
RING
POTS
5
NC
Unused
6
NC
Unused_
Summary of Contents for ALL126AS3
