Allmatic BIOS1 24V, Manual, Page: 28 / 120

8/20 6-1622400 rev. 8 19/01/2022
RELAY 1
RELAY 2
RELA
Y 5
RELAY 3
RELAY 4
FUSE 3
FUSE 1
FUSE 2
DISPLAY
EDGE STOP PH1 PH2 OPEN CLOSE PED SS COM LS1 LS2 OGL
+24VDC
GND
+24VDC
TX PHOTO
1-2: FLASH
MO
TOR
BA
TTER
Y CHARGER
POWER
ON
UP DOWN
MENU
SS
1 2 3 4 5 6 7
RADIO
21
22
23
24
25
26
J5
J7
J4
J3
J2
RAD1
+
-
ON DIP-SWITCH
EDGE PH2 PH1 STOP
9 10 11 12 13 14 15 16 17 18 19 20 8
PE
ENG
ITA ENG FRA ESP NLD TUR
5.3 - MALFUNCTION SIGNALLINGS
5.4 - SIGNALLING LED
LED COLOUR DESCRIPTION
EDGE RED Safety signalling, Led normally ON.
PH2 RED Safety signalling, Led normally ON.
PH1 RED Safety signalling, Led normally ON.
STOP RED Safety signalling, Led normally ON.
OPEN GREEN Led normally OFF. It is turned on when the button is pressed.
CLOSE GREEN Led normally OFF. It is turned on when the button is pressed.
PED GREEN Led normally OFF. It is turned on when the button is pressed.
SS GREEN Led normally OFF. It is turned on when the button is pressed.
LS1 RED Led is turned on when the limit switch is not activated.
LS2 RED Led is turned on when the limit switch is not activated.
RADIO RED Led ON with a radio transmission or interferences.
POWER ON GREEN Led normally ON. It shows the presence of the power supply.
DISPLAY DESCRIPTION
eme
Memory error: the external memory not installed or not recognised.
ee
x
Memory error during the writing: the value x is a number from 1 to 6. In the event of the error, contact the technical assistance.
eLs
Limit switches error: opening and closing limit switches are busy in the same time
efO
Impact sensor intervention.
eeD
Safety edge intervention.
eph
Malfunctioning of photocells.
eth
Thermical intervention to preserve the control unit.
fuL
Full external memory.
err
Memory error during functions viewing memory location or cancellation of a single transmitter.
NOTE - The visualization of an error on the display persists until the “DOWN” button is pressed or until another command is given.
WARNING - the restore from an
EE
x error must be carried out through one of the 3 buttons of the control unit (UP, MENU or DOWN).
WARNING!
If the supply fuse blows with the motor blocked, check the intervention thresholds of the current sensor. A correct configuration of
the SEN and SEL parameters limits the possibility of failure of the power supply fuse. To avoid the intervention of the supply fuse in the condition of
motor block it is advisable to use the inversion function on the obstacle.
FIG. 5