Allmand Maxi-Power MP25 T4F, Operator'S Manual

Page: 53 / 68

Not for
Reproduction
53
5. Periodic Inspection
5-15
5.4.21 Change Coolant
Every 2 years
When removing the radiator cap, be sure to stop the machine and wait until the coolant cools down.
A030145
<Procedure>
1. To drain coolant, remove the radiator cap [A], then loosen the
drain valve [B].
2. Be sure to also open the drain plug [C] on the engine cylinder
block for drainage.
3. Drain coolant of reserve tank.
4. When the coolant is completely drained out, close each drain
valve [B] and drain plug [C], and supply new coolant from the filler
port of radiator [D].
5. After changing the coolant, run the engine under unload
operation for 2 to 3 minutes, then stop it. Check the coolant level
again and replenish it if necessary.

For the details of replacement, refer to engine operation
manual.
H990432
Caution in changing coolant

Be sure to stop the machine and loosen the radiator cap slowly,
after the coolant water is sufficiently cooled and the inner pressure
is released, then take the cap off. If the following procedures are
neglected, the radiator cap could be blown by the internal
pressure or hot moisture air be blown out to cause burning.
Therefore, make sure to carry out them without fail.

LLC (Antifreeze) is a toxic material.

When a person has drunk LLC (Antifreeze) by accident, make him
vomit and make him see a doctor immediately.

When a person gets LLC (Antifreeze) in his eyes, wash the eyes
with clean running water and make him see a doctor immediately.

When LLC (Antifreeze) is stored, put it in a container with an
indication saying "LLC (Antifreeze) inside" and seal it up, then
Keep it in a place away from children.

Beware of flames.
A
D
C B